Ultralevel EUL 2000 – 2mm Epoxy Self Levelling Underlay
Ultralevel EUL 2000 has been formulated to achieve a smooth flat surface with ease of application and maximum flow on existing uneven concrete floor. Underlay may be coated with Bostik Epoxy resin based flooring systems.
COVERAGE
Primer E2 – 5 – 6m2 / kg Ultralevel EUL2000 – 5.3 m2 / 19 kg pack @2mm thickness Coverage may vary based on nature of substrate.
PACKAGING
Primer E2 : 1 & 5 Kg.
Ultralevel EUL 2000 : 19 kg (composite pack of Base, Hardener & Filler)
APPLICATION PROCEDURE
Surface Preparation
- The concrete surface must be hard, sound and dry.
- Dust and paint should be removed from substrate prior to application of primer.
- New concrete floor must be allowed to cure for at least 28 days and moisture should not exceed 5%.
- Existing concrete floor surface should be mechanically prepared by scrubbing / grinding.
- Dust and debris should be removed using vacuum equipment.
- Expansion or movement joint should be brought through to finished surface.
PRIMING
All areas to be treated with Bostik Ultra level EUL 2000 must be primed with Primer E2, Add entire content of component B (hardener) into component A (base) of Primer E2. Mix thoroughly for 2 minutes with slow speed stirrer and apply by brush / roller on prepared surface. Second coat may be required depending upon the condition and porosity of the concrete substrate. Proper priming is required to avoid blister or pin holes in the final coating. Allow the Primer to tack free.
MIXING
- Bostik Ultra level EUL 2000 is supplied in a pre-weighed pack consisting of three components Base, Hardener and Filler.
- Pour hardener into the base and mix with the suitable mixing paddle to obtain a homogeneous mix.
- Add filler to the homogeneous mix and stir for 3 to 5 minutes.
- One or more pack may be mixed simultaneously to ensure quick rate of application.
- Pot life – 30 minutes @ 300C.
- Initial cure – 18 hrs.
- Full cure – 7 days.
- Colour – Translucent / Pigmented.
- Compressive strength – 65 N / mm2
- Flexural strength – 15N / mm2
- Tensile strength – 10 N / mm2
- Pot life – 30 minutes @ 300C.
- Initial cure – 18 hrs.
- Full cure – 7 days.
- Colour – Translucent / Pigmented.
- Compressive strength – 65 N / mm2
- Flexural strength – 15N / mm2
- Tensile strength – 10 N / mm2
- Mixed material should be poured on to already primed surface.
- Material should spread evenly and slowly to get desired thickness by using serrated trowel.
- The surface should be gently rolled with spike roller to remove entrapped air and trowel marks.
- The applied area should be protected during application and the initial curing time.
- Economical.
- Very fast application.
- Good mechanical properties.
- Seamless floor which is cleaned to maintain hygiene
- Resistance to wide range of chemicals.