Ultralevel ESL 1000/ 2000 / 3000

APPLICATION PROCEDURE

Surface Preparation

• The concrete surface must be hard, sound and dry.
• Dust, paint should be removed from substrate prior to application of primer.
• New concrete floor must be allowed to cure for at least 28 days and moisture should not exceed 5%.
• Existing concrete floor surface should be mechanically prepared by scrubbing / grinding.
• Dust and debris should be removed using vacuum equipment.
• Expansion or movement joint should be brought through to finished surface.

PRIMING

• All areas to be treated with Bostik Ultralevel ESL 1000 / 2000 must be primed with Primer E2, add entire content of component B (hardener) into component A (base) of Primer E2.
• Mix thoroughly for 2 minutes with slow speed stirrer and apply by brush / roller on prepared surface.
• Second coat may be required depending upon the condition and porosity of the concrete substrate.
• Proper priming is required to avoid blister or pin hole in the final coating.
• Allow the Primer to tack free.

MIXING

• Bostik Ultralevel ESL 1000 / 2000 is supplied in pre weighed packs consisting of Base, Hardener, Filler & Colour concentrate.
• Base should be thoroughly stirred before adding the hardener.
• Pour hardener into the base and mix for 2 minutes with slow speed stirrer using suitable mixing paddle. Add colour concentrate to the mixed base – hardener and mix further till achieve a uniform mix.
• Finally add filler to the homogeneous mix and stir for 2 minutes.
• One or more pack may be mixed simultaneously to ensure quick rate of application.